DEN-900DX: ALUSPOT DELUXE
Everything you need for aluminum repair. Lockable system keeps tools organized, clean and safe. This Deluxe version is Ford Approved and includes a bridge puller, 3rd drawer and dust cover.
DEN-505/220V: The MAXI - Multiple Pull Station
The original MAXI is a 220 Volt single phase dent pulling station that provides the technician with the power they need to shrink, pull rocker panels, hail damage, creases, dents in hard to access areas and all types of metal damage.
DEN-1690: BORON KILLER DRILL BIT
This drill bit was created to specifically cut spot welds from Boron Steel. Ultra High Strength (UHSS) also known as Boron Steel is used by many vehicle manufacturers to lighten the vehicles weight and increase gas mileage while increasing structural strength. Boron steel is about 3 times stronger than regular High Strength Steel.
DEN-3DX: DIGITAL TRAM GAUGE
Taking point-to-point measurements from 1’4″ to 11’11” (400-3640 mm) the digital tram gauge user can measure in feet, inches, 1/16”s of an inch and metric measurements with the touch of a button.
DEN-3: TELESCOPING TRAM GAUGE
Take point-to-point measurement from 3 to 10 ½ feet (950-3250 mm). Tape reads in both metric and NCSCI, American National Standard. Measuring accuracy is +- 1.0 mm. No sections to add up or put together.
DEN-3TC5A: 5 METER TRAM GAUGE
Telescopic measuring trams are great for writing estimates or to quickly spot check a frame pull. Measures 3’6″ to 15’4″.
DEN-3TC3A: 3 METER TRAM GAUGE
Telescopic measuring trams are great for writing estimates or to quickly spot check a frame pull. Measures 2’6″ to 9’2″.
DEN-15DX: SPOT ANNIHILATOR KIT
The "Original Spitznagel" Spot Weld Drill that applies the correct cutting pressure pneumatically. No pushing needed, the patented valved cylinder applies gentle pressure toward the panel. Helps prevent the bits from slamming and applies correct cutting pressure.
DEN-700DX: ELIMINATOR
The Deluxe Kit includes our new decal eraser for water based paint, the regular decal, 6 fiber discs, single and a double fiber disk holder, 1 course and 1 fine 23mm brush and the new 11mm course and fine brush with holder. Everything organized in a blow molded case.